Mercedes Sprinter W907 W910 Sliding Door Moulding Trim Left N/S A9106900600

Visual condition of the part

The product shows signs of use visible in the photos.

Mercedes Sprinter W907 W910 Sliding Door Moulding Trim Left N/S is an original body component designed for installation on the driver's side. It provides an aesthetic finish to the edge of the sliding door and additional protection for the bodywork surface against minor mechanical damage. Thanks to its factory-fit design, it serves as a functional and visually cohesive addition to the side of the bodywork of your Sprinter.

Specifications and technical data

• SKU: A9106900600
• Mark: Mercedes (Genuine OE)
• Condition: Used
• OEM Part Number: A9106900600
• Substitutable numbers: A9106900600, A 910 690 06 00
• Location on the vehicle: Left
• Category: Body Mouldings & Trims

Purpose and compatibility for Mercedes Sprinter W907/W910

The presented moulding is designed specifically for Mercedes Sprinter W907 and W910 generation models with sliding doors. The component's construction is adapted to the factory panel profile, allowing for precise alignment with the body line without the need for modifications. Its original origin guarantees compatibility with factory mounting points and correct geometry relative to the door and adjacent panels.

Protective and aesthetic function of the moulding

The moulding belongs to the Protective and decorative mouldings category, combining a protective function with an improvement in the vehicle's appearance. Its purpose is to:

• protect the lower and middle part of the sliding door against minor impacts and abrasions,
• mask any potential irregularities on the edge of the panel,
• maintain a consistent side body line in accordance with the manufacturer's standard,
• reduce the risk of corrosion in the sensitive door area.

As a result, the moulding helps keep the vehicle in good visual condition, which is important both for daily use and for the potential resale of the vehicle.

Vehicle placement and installation aspects

The component is intended for installation on the left side of the vehicle, on the outer surface of the sliding door. The mounting layout is prepared for factory solutions used by the manufacturer, which facilitates work for a workshop or a person involved in vehicle outfitting. Proper positioning of the moulding relative to the door edge allows for maintaining an even gap and a correct side line, which is essential during body and paint repairs as well as when replacing damaged body components.

Characteristics of the used product

The moulding comes from the used parts segment, which means it was previously used in a vehicle. Such components are often chosen for post-accident repairs and body maintenance because they allow for maintaining factory specifications while optimizing costs. The original construction promotes trouble-free installation and reduces the risk of mismatching, which is typical for aftermarket parts with a universal profile.

Technical support and additional information

Before purchasing, it is worth verifying the compatibility of the component with the specific Sprinter body version and the sliding door configuration of your vehicle. In case of expanding the side bodywork or replacing several components at once, the visual and technical consistency of the mouldings is of significant importance for the final repair result.

If you are planning a comprehensive repair or modernization of the sliding door side area in your Mercedes and need other elements from the same group, such as covers, overlays, or additional mouldings, check the available parts in the Mercedes protective and decorative mouldings category.

To better take care of the durability of installed second-hand components, it is worth familiarizing yourself with practical tips regarding operation and maintenance – detailed advice can be found in the article How to extend the life of used car parts?.